FAL – Final Assembly Line

MK Test regularly supplies testing equipment for final assembly lines (FAL) of aircraft and vehicles. While components need to be tested when leaving their production stations, final assembly testing provides an absolute assurance of reliability, to the end customer.

For many installations, this final stage testing is the last point of checking the whole control system, before computerised controls, aided by a pilot or driver, take over. MK Test is familiar with providing interfaces to enable final testing, whatever the product.

Test systems are typically supplied in Distributed format, a main control console connected to remote switching satellite units. This eliminates the need for long interface cables and adaptors, and speeds up the hook up process, often the most time consuming stage of a test process. Test reports diagnose faults and pinpoint failures to specific areas of the product to minimise delays and impact on production at this critical stage.

Application Overview

Final Assembly Line

Model Summary & Datasheets

Request Full Specification

Request Full Specification

Request Full Specification

Model-BLTU Auto Bond & Loop

Model-BLTU Auto Bond & Loop

Combined Ground Bond and Ground Loop Tester
Computer Controlled, Intuitive MK software
Automatic download of test requirement
Step by Step graphical operator instruction
Automatic upload of test results
Hot Swap dual battery port – enables continuous testing
Active test probes with LED status indication
Compact and lightweight for single person operation
Wide range of Bond Probes and Loop Clamps

Request Full Specification

Contact MKTest